STEP 1: To ensure comfortable insertion, apply a water-based lubricant to the opening of the pump.


STEP 2: Insert your penis into the cylinder chamber. Unless using a Bathmate pump, where your penis must be flaccid, you can be hard, semi-erect or soft. Keep testicles outside of the cylinder.


STEP 3: Press the base of the pump firmly to your body, creating an air tight seal between your skin and the pump. It might be necessary to trim the hair around the base of the penis so the pump can sit completely flat against your pubic bone.


STEP 4: Depending on the type of dick pump you have, either place your finger over the quick release valve, or twist it so that it’s shut.


STEP 5: Begin to pump slowly. Between each pump allow your penis to adjust to the changing pressure within the chamber before squeezing the bulb for a second or third time.


STEP 6: Continue pumping until fully erect.


STEP 7: Remove your penis from the pump and check it for any unusual discoloration. It might look a bit more purple than usual, but if there is any serious change in colour or pain, then stop. If everything feels alright, then after a short massage of your shaft (use lube for extra comfort) you can go for another round of pumping if required.

STEP 8: Once you’ve reached maximum length at this time, release the air pressure valve, or turn to open it. This will let the air of out the chamber, allowing you to easily remove your penis.

A few safety points
Using a penis pump on a regular basis is completely safe and healthy, but keep an eye out for the following things.


While it might take a bit of time to get used to the sucking sensation of a penis pump, there should never be any pain or discomfort when using a penis enlarger. If there is, then you must stop immediately.


The same must be said for any unusual discolouring of the penis. If there is a severe change in colour, then stop and seek medical help.

Here is a link of our video on Youtube: Video:How to use a pump?